Friday, October 25, 2013

New Battery & Tray Restoration

Time for a new Starter Battery as Betty's battery has trouble starting after a long drive and only giving 11.78V at best.

Strange how the battery was struggling when the engine was warm but it is in the direct flow of the cooling air.

So new Battery was purchased and a free morning to fit it.


The old battery was a 48 A/h 220A and appears to be the original Brazilian battery as it was made in Brazil. So could be from 2004!


Upon removal it was clear that the battery tray was in need of some rust removal and restoration. Major water trap and also a weak spot for any bus.

Rust is only surface but needed treatment before replacing the battery.


After some cleaning and wire brushing the worst was removed. 


Surface treated with Hamerite rust removing Gel. Cleaned back again. No More rust! Then primed with the Hamerite Primer.


Resprayed with Hamerite smooth spray. Quite a good match to the VW Candy White. Close enough for inside the engine bay.



New YUASA 50A/h 440A Silver 5000 Battery. Should last a while and not too big for the Alternator to charge.

Starts after 2 Seconds and totally smooth turn over from the starter motor.

Will now be able to connect the Leisure Battery back up and think about replacing the rubbish split charge relay for a smartcom.


3 comments:

  1. Wow, man.......I ...er ...Very good recovery.....but look at your outer panel inner seam near the tray..........swollen with rust ......that needs cutting out...or serious air tools stuff..........that's not good, but having said that all works good, looks good, especially the big battery :).

    ReplyDelete
  2. I know I know. BUT I have to have something to do when the whole battery tray and rear quarter pannel rusts out. It was only the seam where the water runs down from the air vent. It is not that bad and hopefully treated it for now.

    ReplyDelete
  3. Is that the gibbon giving advice on ignoring areas of rust?!?! Ahem!.... ..... .... :)

    ReplyDelete