Started early and welded in outer valance. Primed up interior first.
Neil's project looking very smooth.
New bits'n'bobs.
All welded in.
Ground back with grinding disc.
Then cleaned up with flap disc and finaly air sander.
All washed down with panel wipe and keyed up with abrasive paper and primer painted.
Lower upper clip edge trimmed and punched.
Outer lower clip repair joggled, cut, adjusted, washed, keyed and primer painted.
So pleased with this first fitment!!! only needed a slight trim on one edge to fit snug.
Started welding in then ran out of argon co2 mix!! Cleaned up welds.
No comments:
Post a Comment